Design Choices for IPv6 Networks
draft-ietf-v6ops-design-choices-00
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
|
|
---|---|---|---|
Author | Philip Matthews | ||
Last updated | 2013-08-22 (Latest revision 2013-02-18) | ||
Replaces | draft-matthews-v6ops-design-guidelines | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | WG Document | |
Document shepherd | (None) | ||
IESG | IESG state | Expired | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document presents advice on the design choices that arise when designing IPv6 networks (both dual-stack and IPv6-only). The intended audience is someone designing an IPv6 network who is knowledgeable about best current practices around IPv4 network design, and wishes to learn the corresponding practices for IPv6.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)