Skip to main content

MPLS Extension Header Encodings
draft-jags-mpls-ext-hdr-00

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Jaganbabu Rajamanickam , Rakesh Gandhi , Jisu Bhattacharya , Bruno Decraene , Royi Zigler , Weiqiang Cheng , Luay Jalil
Last updated 2022-03-02
Replaces draft-jags-mpls-ext-hdr-entropy-lbl
Replaced by draft-jags-mpls-mna-hdr
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-jags-mpls-mna-hdr
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document uses the Multiprotocol Label Switching (MPLS) Entropy Label (EL) extensions defined in draft-decraene-mpls-slid-encoded- entropy-label-id or a new Special Purpose Label to indicate the presence of MPLS Extension Header (MEH) in an MPLS label stack. It defines different MPLS Extension Header encoding formats to carry additional data in the MPLS label stack that can influence forwarding decision and to carry additional data after the Bottom of the MPLS label stack.

Authors

Jaganbabu Rajamanickam
Rakesh Gandhi
Jisu Bhattacharya
Bruno Decraene
Royi Zigler
Weiqiang Cheng
Luay Jalil

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)