Asymmetric IPv6 for IoT Networks
draft-jiang-asymmetric-ipv6-03
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
|---|---|---|---|
| Authors | Sheng Jiang , Guangpeng Li , Brian E. Carpenter | ||
| Last updated | 2020-11-16 (Latest revision 2020-05-14) | ||
| Replaced by | draft-li-native-short-addresses | ||
| RFC stream | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a new approach to IPv6 header compression for use in scenarios where minimizing packet size is crucial but routing performance must be maximised.
Authors
Sheng Jiang
Guangpeng Li
Brian E. Carpenter
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)