A YANG Data Model for Attachment Circuit as a Service with UDP Tunnel Support
draft-jlu-dmm-udp-tunnel-acaas-02
| Document | Type |
Replaced Internet-Draft
(dmm WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | John Kaippallimalil , Luis M. Contreras , Uma Chunduri | ||
| Last updated | 2026-03-15 (Latest revision 2025-12-04) | ||
| Replaced by | draft-ietf-dmm-udp-tunnel-acaas-extn | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Yang Validation | 0 errors, 0 warnings | ||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | Adopted by a WG | |
| Document shepherd | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-dmm-udp-tunnel-acaas-extn | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Delivery of network services over a Layer 3 tunnel assumes that the appropriate setup is provisioned over links that connect the customer termination points and provider network. The required setup to allow successful data exchange over these links is referred to as an attachment circuit (AC) while the underlying link for carrying network services is referred to as "bearer", in this case a Layer 3 UDP tunnel. This document specifies an extension for UDP tunnel as Layer 3 bearer to the YANG service data model for AC.
Authors
John Kaippallimalil
Luis M. Contreras
Uma Chunduri
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)