Diameter Group Signaling
draft-jones-diameter-group-signaling-01
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Mark Jones | ||
Last updated | 2012-09-08 (Latest revision 2012-03-07) | ||
Replaced by | draft-ietf-dime-group-signaling | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-dime-group-signaling | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
In large network deployments, a single Diameter peer can support over a million concurrent Diameter sessions. Recent use cases have revealed the need for Diameter peers to apply the same operation to a large group of Diameter sessions concurrently. The Diameter base protocol commands operate on a single session so these use cases could result in many thousands of command exchanges to enforce the same operation on each session in the group. In order to reduce signaling, it would be desirable to enable bulk operations on all (or part of) the sessions managed by a Diameter peer using a single or a few command exchanges. This document specifies the Diameter protocol extensions to achieve this signaling optimization.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)