Layer 2 Relay Agent Information
draft-joshi-dhc-l2ra-00
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Bharat Joshi , Pavan Kurapati | ||
| Last updated | 2007-11-13 | ||
| Replaced by | draft-ietf-dhc-l2ra | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-dhc-l2ra | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
In some networks, DHCP servers rely on Relay Agent Information option appended by Relay Agents for IP address and other parameter assignment policies. This works fine when End Hosts are directly connected to Relay Agents. In some network configurations, one or more Layer 2 devices may reside between DHCP clients and Relay agent. In these network scenarios, it is difficult to use the Relay Agent Information option for IP address and other parameter assignment policies effectively. So there is a need for the closest Layer 2 device to append Relay Agent Information option in DHCP messages. These devices are typically known as Layer 2 Relay Agents. This document aims to describe the network scenarios where Layer 2 Relay Agent is in use and also how it handles DHCP messages.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)