Requirements for Point-to-Multipoint Pseudowire
draft-jounay-pwe3-p2mp-pw-requirements-02
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Frederic JOUNAY | ||
| Last updated | 2008-10-27 (Latest revision 2008-07-14) | ||
| Replaced by | RFC 7338 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-pwe3-p2mp-pw-requirements | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document presents a set of requirements for providing an unidirectional Point-to-Multipoint PWE3 (Pseudowire Emulation Edge to Edge) emulation. The requirements identified in this document are related to architecture, signaling and maintenance aspects of a Point-to-Multipoint PW operation. They are proposed as guidelines for the standardization of such mechanisms. Among other potential applications Point-to-Multipoint PWs SHOULD be used to optimize the support of multicast services as defined in the Layer 2 Virtual Private Network working group.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)