Frame Relay Transport and Encapsulatiion over Psevdo-Wires
draft-kamapabhava-fr-pwe3-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Claude Kawa , Andrew G. Malis , Prayson Pate , Ravi Bail Bhat , Nishit Vasavada | ||
Last updated | 2002-04-15 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document defines frame relay pseudo-wire specific aspects. A frame relay pseudo wire exists between network edge nodes and support as faithfully as possible an instance of a frame relay service. A frame relay pseudo-wire is a mechanism that allows frame relay protocol control information and payload to be carried over IP or MPLS Packet Switched Networks.
Authors
Claude Kawa
Andrew G. Malis
Prayson Pate
Ravi Bail Bhat
Nishit Vasavada
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)