Skip to main content

OSPF Strict-Mode for BFD
draft-ketant-lsr-ospf-bfd-strict-mode-03

Document Type Replaced Internet-Draft (lsr WG)
Expired & archived
Authors Ketan Talaulikar , Peter Psenak , Albert Fu , Rajesh Shetty
Last updated 2020-01-06 (Latest revision 2019-11-01)
Replaced by draft-ietf-lsr-ospf-bfd-strict-mode
RFC stream Internet Engineering Task Force (IETF)
Intended RFC status (None)
Formats
Additional resources Mailing list discussion
Stream WG state Adopted by a WG
Document shepherd (None)
IESG IESG state Replaced by draft-ietf-lsr-ospf-bfd-strict-mode
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document specifies the extensions to OSPF that enables a router and its neighbor to signal their intention to use Bidirectional Forwarding Detection (BFD) for their adjacency using link-local advertisement between them. The signaling of this BFD enablement, allows the router to block and not allow the establishment of adjacency with its neighbor router until a BFD session is successfully established between them. The document describes this OSPF "strict-mode" of BFD establishment as a prerequisite to adjacency formation.

Authors

Ketan Talaulikar
Peter Psenak
Albert Fu
Rajesh Shetty

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)