Skip to main content

Use Cases for an Interface to BGP Protocol
draft-keyupate-idr-i2rs-bgp-usecases-02

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Keyur Patel , Russ White , Susan Hares
Last updated 2016-09-22 (Latest revision 2016-03-21)
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

A network routing protocol like BGP is typically configured and analyzed through some form of Command Line Interface (CLI) or NETCONF. These interactions to control BGP and diagnose its operation encompass: configuration of protocol parameters, display of protocol data, setting of certain protocol state and debugging of the protocol. Interface to the Routing System's (I2RS) Programmatic interfaces provides an alternate way to control and diagnose the operation of the BGP protocol. I2RS may be used for the configuration, manipulation, analyzing or collecting the protocol data. This document describes set of use cases for which I2RS can be used for BGP protocol. It is intended to provide a base for the solution draft describing a set of interfaces to the BGP protocol.

Authors

Keyur Patel
Russ White
Susan Hares

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)