Bulk DHCPv4 Lease Query

Document Type Replaced Internet-Draft (individual)
Authors Kim Kinnear  , Bernie Volz  , Neil Russell  , Mark Stapp  , D.T.V. Rao  , Bharat Joshi  , Pavan Kurapati 
Last updated 2009-03-11 (latest revision 2008-11-03)
Replaced by RFC 6926
Stream (None)
Intended RFC status (None)
Expired & archived
plain text pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-dhc-dhcpv4-bulk-leasequery
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


The Dynamic Host Configuration Protocol for IPv4 (DHCPv4) has been extended with a Leasequery capability that allows a requestor to request information about DHCPv4 bindings. That mechanism is limited to queries for individual bindings. In some situations individual binding queries may not be efficient, or even possible. This document expands on the DHCPv4 Leasequery protocol to allow for bulk transfer of DHCPv4 address binding data via TCP.


Kim Kinnear (kkinnear@cisco.com)
Bernie Volz (volz@cisco.com)
Neil Russell (nrussell@cisco.com)
Mark Stapp (mjs@cisco.com)
D.T.V. Rao (ramakrishnadtv@infosys.com)
Bharat Joshi (bharat_joshi@infosys.com)
Pavan Kurapati (pavan_kurapati@infosys.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)