Diameter Proxy Mobile IPv6: Support For Mobile Access Gateway and Local Mobility Anchor to Diameter Server Interaction
draft-korhonen-dime-pmip6-04
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Jouni Korhonen , Julien Bournelle , Ahmad Muhanna , Kuntal Chowdhury , Ulrike Meyer | ||
Last updated | 2010-04-12 (Latest revision 2008-09-15) | ||
Replaced by | draft-ietf-dime-pmip6 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-dime-pmip6 | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This specification defines the Diameter support for the Proxy Mobile IPv6 and the corresponding mobility service session setup. The policy information needed by the Proxy Mobile IPv6 is defined in mobile node's policy profile, which could be downloaded from the Diameter server to the Mobile Access Gateway once the mobile node roams into a Proxy Mobile IPv6 Domain and performs access authentication.
Authors
Jouni Korhonen
Julien Bournelle
Ahmad Muhanna
Kuntal Chowdhury
Ulrike Meyer
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)