State Refresh in PIM-DM
draft-kouvelas-pim-refresh-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Dino Farinacci , Isidor Kouvelas , Kurt Windisch | ||
Last updated | 1999-02-24 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This proposal extends the PIM-DM [1] protocol specification by intro- ducing the PIM State-Refresh control message. When an (S,G) entry is created in a router for a directly connected source, if the interface directly connected to the source is the incoming interface for the entry, a new timer is started: the State- Refresh-Timer [SRT(S,G)]. The State-Refresh-Timer controls periodic transmission of the PIM State-Refresh message, which is propagated hop-by-hop down the (S,G) RPF tree. When received by a router on the RPF interface, the State-Refresh message causes existing prune state to be refreshed. Addition of this heartbeat message solves many of the current problems with PIM-DM. It prevents the periodic timeout of prune state in routers, greatly reducing the re-flooding of multicast traffic down the pruned branches that expire periodically. It also causes topology changes to be realised quicker than the traditional 3 minute timeout.
Authors
Dino Farinacci
Isidor Kouvelas
Kurt Windisch
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)