Semantic Address Based Instructive Routing for Satellite Network
draft-lhan-satellite-instructive-routing-03
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Lin Han , Alvaro Retana , Richard Li | ||
| Last updated | 2024-03-04 (Latest revision 2023-09-01) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document presents a method to do IP routing over satellite network that consists of LEO (Low Earth Orbit) satellites and ground- stations. The method uses the source routing mechanism. The whole routing info is obtained by path calculation. The routing path information is converted to be a list of instructions and embedded into user packet's IPv6 extension header. At each hop or each satellite, the routing process engine will forward the packet based on the specified instruction for the satellite. Until the packet reaches the edge of satellite network, or the last satellite, the packet will be sent to a ground station.
Authors
Lin Han
Alvaro Retana
Richard Li
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)