Purge Originator Identification for OSPF
draft-li-lsr-ospf-purge-originator-02
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Active".
Expired & archived
|
|
|---|---|---|---|
| Authors | Zhenqiang Li , Changwang Lin | ||
| Last updated | 2025-01-09 (Latest revision 2024-07-08) | ||
| RFC stream | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
In RFC6232(Purge Originator Identification TLV for IS-IS), ISIS POI (Purge Originator Identification) TLV is added to the purge LSP to record the system ID of the IS generating it. At present, OSPF purge does not contain any information identifying the Router that generates the purge. This makes it difficult to locate the source router. While OSPF protocol is difficult to add additional content to the purge LSA, this document proposes generating a POI LSA together with a purge LSA to record the router ID of the router generating the purge. To address this issue, this document defines a POI LSA to record the router ID of the OSPF generating it.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)