Skip to main content

Service-Oriented MPLS Path Programming (MPP)
draft-li-mpls-path-programming-00

Document Type Expired Internet-Draft (individual)
Expired & archived
Author Zhenbin Li
Last updated 2018-09-06 (Latest revision 2018-03-05)
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Segment Routing has been proposed to cope with the use cases in traffic engineering, fast re-reroute, service chain, etc. It can leverage existing MPLS dataplane without any modification. In fact, the label stack capability in MPLS would have been utilized well to implement flexible path programming to satisfy all kinds of requirements of service bearing. But in the distributed environment, the flexible programming capability is difficult to implement and always confined to reachability. As the introducing of central control in the network, the flexible MPLS programming capability becomes possible owing to two factors: 1. It becomes easier to allocate label for more purposes than reachability; 2. It is easy to calculate the MPLS path in a global network view. Moreover, the MPLS path programming capability can be utilized to satisfy more requirements of service bearing in the service layer which is defined as service-oriented MPLS path programming. This document defines the concept of MPLS path programming, then proposes use cases, architecture and protocol extension requirements in the service layer.

Authors

Zhenbin Li

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)