Support for Path MTU (PMTU) in the Path Computation Element Communication Protocol (PCEP).
draft-li-pce-pcep-pmtu-00
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
|---|---|---|---|
| Author | Cheng Li | ||
| Last updated | 2019-09-08 (Latest revision 2019-03-07) | ||
| Replaces | draft-dhody-pce-pcep-pmtu | ||
| Replaced by | draft-ietf-pce-pcep-pmtu, draft-ietf-pce-pcep-pmtu | ||
| RFC stream | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Path Computation Element (PCE) provides path computation functions in support of traffic engineering in Multiprotocol Label Switching (MPLS) and Generalized MPLS (GMPLS) networks. The Source Packet Routing in Networking (SPRING) architecture describes how Segment Routing (SR) can be used to steer packets through an IPv6 or MPLS network using the source routing paradigm. A Segment Routed Path can be derived from a variety of mechanisms, including an IGP Shortest Path Tree (SPT), explicit configuration, or a Path Computation Element (PCE). Since the SR does not require signaling, the path maximum transmission unit (MTU) information for SR path is not available. This document specify the extension to PCE communication protocol (PCEP) to carry path (MTU) in the PCEP messages.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)