Path Computation Element Communication Protocol (PCEP) Extension for Path Segment in Segment Routing (SR)
draft-li-pce-sr-path-segment-08

Document Type Replaced Internet-Draft (pce WG)
Last updated 2019-10-11 (latest revision 2019-08-19)
Replaced by draft-ietf-pce-sr-path-segment
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream WG state Adopted by a WG
Document shepherd No shepherd assigned
IESG IESG state Replaced by draft-ietf-pce-sr-path-segment
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-li-pce-sr-path-segment-08.txt

Abstract

The Path Computation Element (PCE) provides path computation functions in support of traffic engineering in Multiprotocol Label Switching (MPLS) and Generalized MPLS (GMPLS) networks. The Source Packet Routing in Networking (SPRING) architecture describes how Segment Routing (SR) can be used to steer packets through an IPv6 or MPLS network using the source routing paradigm. A Segment Routed Path can be derived from a variety of mechanisms, including an IGP Shortest Path Tree (SPT), explicit configuration, or a Path Computation Element (PCE). Path identification is needed for several use cases such as performance measurement in Segment Routing (SR) network. This document specifies extensions to the Path Computation Element Communication Protocol (PCEP) to support requesting, replying, reporting and updating the Path Segment ID (Path SID) between PCEP speakers.

Authors

Cheng Li (chengli13@huawei.com)
Mach Chen (mach.chen@huawei.com)
Weiqiang Cheng (chengweiqiang@chinamobile.com)
Jie Dong (jie.dong@huawei.com)
Zhenbin Li (lizhenbin@huawei.com)
Rakesh Gandhi (rgandhi@cisco.com)
Quan Xiong (xiong.quan@zte.com.cn)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)