Skip to main content

Segment Path Programming (SPP)
draft-li-spring-segment-path-programming-00

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Zhenbin Li , Igor Milojevic
Last updated 2016-04-19 (Latest revision 2015-10-17)
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Segment Routing for unicast traffic has been proposed to cope with the usecases in traffic engineering, fast re-reroute, service chain, etc. The document generalizes more use cases based on segment and proposes the concept of Segment Path Programming. In the field of Segment Path Programming: 1. The Segment used in the programmed segment path is not only used in the forwarding plane, but also used in the control plane. 2. The programmed segment path is not only used in the transport layer, but also used in the service layer. Accordingly this document proposes use cases, architecture and protocol extension requirements for the Segment Path Programming (SPP).

Authors

Zhenbin Li
Igor Milojevic

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)