Label Distribution Protocol (LDP) Send Hold Timer
draft-lin-mpls-ldp-holdtimer-04
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Changwang Lin , 黄智博 | ||
| Last updated | 2026-03-17 (Latest revision 2025-09-13) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document defines the SendHoldTimer and SendHoldTimer_Expires event in the LDP protocol. The implementation of SendHoldTimer helps address situations where the local system detects that the remote system has not processed LDP messages but has not terminated the LDP session. The document specifies that when the SendHoldTimer expires, the local system should close the LDP session connection, rather than solely relying on the remote system for session termination. This document updates RFC5036.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)