Dynamic IPv4 Provisioning for Lightweight 4over6
draft-liu-softwire-lw4over6-dhcp-deployment-05
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Cong Liu , Qi Sun , Jianping Wu | ||
Last updated | 2015-04-15 (Latest revision 2014-10-12) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Lightweight 4over6 [I-D.ietf-softwire-lw4over6] is an IPv4 over IPv6 hub and spoke mechanism that provides overlay IPv4 services in an IPv6-only access network. Provisioning IPv4 addresses and port set to customers is the core function of Lightweight 4over6 control plane. [I-D.ietf-softwire-lw4over6] illustrates how to use DHCPv6 for deterministic IPv4 provisioning. This document discusses how to provision IPv4 parameters by using dynamic IPv4 provisioning protocols such as DHCPv4 over DHCPv6 [RFC7341]. This document describes a dynamic IPv4 provisioning mode for Lightweight 4over6 that uses DHCPv4 over DHCPv6 [RFC7341] for IPv4 address provisioning.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)