Using CLA-Specific Endpoint IDs to identify Channel Endpoint
draft-loiseau-dtn-cla-eid-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Lucien Loiseau | ||
| Last updated | 2019-05-24 (Latest revision 2018-11-20) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a specific EID scheme namely "cla" that meets the requirement for endpoint identification as defined in the Bundle Protocol and that also uniquely identifies a Convergence Layer Adapter "channel" and is, in essence, an interface identifier (IID). Such IID is comprised of two parts: a "cla-identifier" part that identifies a specific convergence layer adapter, and a "cla- parameters" part that is a cla-specific list of parameter describing a single channel managed by this convergence layer adapter.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)