Receiver-Driven Multicast Traffic-Engineered Label-Switched Paths
draft-lzj-mpls-receiver-driven-multicast-rsvp-te-02

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Authors Richard Li  , Quintin Zhao  , Christian Jacquenet  , Robert Tao , Telus Communications 
Last updated 2013-04-25 (latest revision 2012-10-22)
Stream (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-lzj-mpls-receiver-driven-multicast-rsvp-te-02.txt

Abstract

This document describes the receiver-driven RSVP-TE P2MP LSP signaling protocol (mRSVP-TE) which is an extension to the Resource Reservation Protocol - Traffic Engineering (RSVP-TE) for the computation and establishment of Receiver-Driven Traffic-Engineered point-to-multipoint (P2MP) and multipoint-to-multipoint (MP2MP) Label Switched Paths (LSPs) in Multi-Protocol Label Switching (MPLS) and Generalized MPLS (GMPLS) networks. The document also describes the mRSVP-TE extensions and procedures for the interworking between mRSVP-TE and the Protocol Independent Multicast (PIM) protocol.

Authors

Richard Li (renwei.li@huawei.com)
Quintin Zhao (quintin.zhao@huawei.com)
Christian Jacquenet (christian.jacquenet@orange.com)
Robert Tao (robert.tao@huawei.com)
Telus Communications (boris.zhang@telus.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)