Transmission of IPv6 Packets over DECT Ultra Low Energy
draft-mariager-6lowpan-v6over-dect-ule-02

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Last updated 2012-11-05 (latest revision 2012-05-02)
Replaced by rfc8105, draft-ietf-6lo-dect-ule
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-mariager-6lowpan-v6over-dect-ule-02.txt

Abstract

DECT Ultra Low Energy is a low power air interface technology that is defined by the DECT Forum and specified by ETSI. The DECT air interface technology has been used world-wide in communication devices for more than 15 years, primarily carrying voice for cordless telephony but has also been deployed for data centric services. The DECT Ultra Low Energy is a recent addition to the DECT interface primarily intended for low-bandwidth, low-power applications such as sensor devices, smart meters, home automation etc. As the DECT Ultra Low Energy interface inherits many of the capabilities from DECT, it benefits from long range, interference free operation, world wide reserved frequency band, low silicon prices and maturity. There is an added value in the ability to communicate with IPv6 over DECT ULE. This document describes how IPv6 is transported over DECT ULE using 6LoWPAN techniques.

Authors

Peter Mariager (pm@rtx.dk)
Jens Petersen (jtp@rtx.dk)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)