Architecture for Fast EAP Re-authentication based on a new EAP method (EAP-FRM) working on standalone mode
draft-marin-eap-frm-fastreauth-03
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Rafael Marin-Lopez , Fernando Pereniguez-Garcia , Fernando Bernal-Hidalgo , Antonio Gomez-Skarmeta | ||
| Last updated | 2011-03-28 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes an architecture aimed for reducing the latency of network access authentication based on the Extensible Authentication Protocol (EAP). The architecture is based on the design of a new EAP method for which a standalone authenticator is used, and does not require any change to the EAP specification or the specifications of existing EAP lower-layers.
Authors
Rafael Marin-Lopez
Fernando Pereniguez-Garcia
Fernando Bernal-Hidalgo
Antonio Gomez-Skarmeta
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)