Building Automation Routing Requirements in Low Power and Lossy Networks
draft-martocci-roll-building-routing-reqs-01

Document Type Replaced Internet-Draft (individual)
Last updated 2009-12-14 (latest revision 2008-10-14)
Replaced by draft-ietf-roll-building-routing-reqs
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
plain text pdf html bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-roll-building-routing-reqs
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-martocci-roll-building-routing-reqs-01.txt

Abstract

The Routing Over Low power and Lossy network (ROLL) Working Group has been chartered to work on routing solutions for Low Power and Lossy networks (LLN) in various markets: Industrial, Commercial (Building), Home and Urban. Pursuant to this effort, this document defines the routing requirements for building automation. Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC-2119.

Authors

Jerry Martocci (jerald.p.martocci@jci.com)
Nicolas Riou (nicolas.riou@fr.schneider-electric.com)
Pieter Mil (pieter.demil@intec.ugent.be)
Wouter Vermeylen (wouter@vooruit.be)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)