Marking Converter for Excess-Marked Traffic
draft-menth-pcn-marking-converter-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Michael Menth , Frank Lehrieder | ||
| Last updated | 2008-07-07 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document proposes an algorithm that converts packet markings of a stream that was excess-marked based on a lower-rate into packet markings that correspond to a stream that was excess-marked based on a higher-rate. It may be applied in the PCN context to convert marked admissible-rate-overload into marked supportable-rate- overload. This allows to perform marked flow termination when packets are excess-marked based on the admissible rate only.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)