Operations, Administration, and Maintenance for MPLS-SR over IP

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Author Greg Mirsky 
Last updated 2019-10-22 (latest revision 2019-04-20)
Stream (None)
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


Segment routing uses source routing paradigm to traffic engineering by specifying segments a packet traverses through the network. MPLS Segment Routing applies that paradigm to an MPLS data plane-based networks. SR-MPLS over IP uses MPLS label stack as a source routing instruction set and uses IP encapsulation/tunneling such as MPLS-in- UDP as defined in RFC 7510 to realize a source routing mechanism across MPLS, IPv4, and IPv6 data planes. This document describes Operations, Administration, and Maintenance operations in SR-MPLS over IP environment.


Greg Mirsky (gregimirsky@gmail.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)