MPLS and Ethernet OAM Interworking
draft-mohan-pwe3-mpls-eth-oam-iwk-01

Document Type Replaced Internet-Draft (individual)
Last updated 2008-07-08
Replaced by draft-ietf-pwe3-mpls-eth-oam-iwk
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
plain text pdf html bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-pwe3-mpls-eth-oam-iwk
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-mohan-pwe3-mpls-eth-oam-iwk-01.txt

Abstract

This document specifies the mapping of defect states between Ethernet Attachment Circuits (ACs) and associated Ethernet Pseudowires (PWs) connected in accordance to the PWE3 architecture [RFC3985] to realize an end-to-end emulated Ethernet service. This document augments the mapping of defect states between a PW and associated AC of the end-to-end emulated service in [PW-OAM-MSG- MAP]. In [PW-OAM-MSG-MAP], Ethernet OAM was not covered due to lack of Ethernet OAM maturity. However, since then, [Y.1731] and[802.1ag] have been completed, and this document specifies the mapping of defect states between Ethernet ACs and corresponding Ethernet PWs. Conventions used in this document The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119.

Authors

Dinesh Mohan (mohand@nortel.com)
Nabil Bitar (nabil.n.bitar@verizon.com)
Simon DeLord (sdelord@uecomm.com.au)
Philippe Niger (philippe.niger@francetelecom.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)