Cumulative DMZ Link Bandwidth and load-balancing
draft-mohanty-bess-ebgp-dmz-00
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
---|---|---|---|
Authors | SATYA R MOHANTY , Aaron Millisor , Arie Vayner | ||
Last updated | 2018-09-04 (Latest revision 2018-03-03) | ||
Replaced by | draft-ietf-bess-ebgp-dmz | ||
RFC stream | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The DMZ Link Bandwidth draft provides a way to load-balance traffic to a destination (which is in a different AS than the source) which is reachable via more than one path. Typically, the link bandwidth (either configured on the link of the EBGP egress interface or set via a policy) is encoded in an extended community and then sent to the IBGP peer which employs multi-path. The link-bandwidth value is then extracted from the path extended community and is used as a weight in the FIB, which does the load-balancing. This draft extends the usage of the DMZ link bandwidth to another setting where the ingress BGP speaker requires knowledge of the cumulative bandwidth while doing the load-balancing. The draft also proposes neighbor- level knobs to enable the link bandwidth extended community to be regenerated and then advertised to EBGP peers to override the default behavior of not advertising optional non-transitive attributes to EBGP peers.
Authors
SATYA R MOHANTY
Aaron Millisor
Arie Vayner
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)