Update of the List of Configurable SCTP Protocol Parameters
draft-morand-tsvwg-sctp-parameters-update-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Lionel Morand , Cedric Bonnet | ||
| Last updated | 2016-09-08 (Latest revision 2016-03-07) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
In the SCTP protocol stack implementations available for deployment in operational networks, it has been usually observed that the list of parameters that can be configured by the operators is often restricted to the list of SCTP protocol parameter values that are recommended for SCTP given in the IETF RFC 4960. However, this list is not exhaustive. This document updates the IETF RFC 4960 by including the SACK delay as part of the list of SCTP protocol parameters that can be configurable by an SCTP administrator. The associated recommended value is also given, according to the IETF RFC 4960
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)