Problem Statement for Generalizing 6TiSCH to Multiple PHYs
draft-munoz-6tisch-multi-phy-nodes-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Jonathan Munoz , Xavier Vilajosana , Tengfei Chang | ||
| Last updated | 2019-01-03 (Latest revision 2018-07-02) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The present document describes the needs that arise when considering to use more than one PHY in a IPv6 over the TSCH mode of IEEE802.15.4e (6TiSCH) network. These considerations are present in: the choice of the PHY, the MAC layer -TSCH- configuration, the 6top protocol, 6LoWPAN and RPL.
Authors
Jonathan Munoz
Xavier Vilajosana
Tengfei Chang
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)