Flow Attribute Notification Protocol Version 2 (FANPv2) Distributed Control Mode
draft-nagami-csr-fanpv2-dcmode-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Yasuhiro Katsube , Ken-ichi Nagami , Akiyoshi Mogi , Shigeo Matsuzawa , Koutarou Ise | ||
| Last updated | 1997-12-29 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This memo describes the specification of FANPv2 (Flow Attribute Notification Protocol version 2) distributed control mode (DC-mode). The FANPv2 is a protocol used by Cell Switch Routers (CSRs) to communicate mapping information between a specific packet flow and a virtual connection that conveys the packet flow. In the DC-mode, the control message exchange for a packet flow between each pair of neighboring CSRs is initiated independently from the message exchange for the same flow between any other pair of CSRs. The DC-mode is applicable to the control of both unicast and multicast cut-through paths.
Authors
Yasuhiro Katsube
Ken-ichi Nagami
Akiyoshi Mogi
Shigeo Matsuzawa
Koutarou Ise
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)