Controlling Filtering Rules Using DOTS Signal Channel
draft-nishizuka-dots-signal-control-filtering-00

The information below is for an old version of the document
Document Type Active Internet-Draft (individual)
Last updated 2018-11-20
Replaced by draft-ietf-dots-signal-filter-control
Stream (None)
Intended RFC status (None)
Formats pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state I-D Exists
Telechat date
Responsible AD (None)
Send notices to (None)
DOTS                                                   K. Nishizuka, Ed.
Internet-Draft                                        NTT Communications
Intended status: Standards Track                               T. Nagata
Expires: May 25, 2019                                            Lepidum
                                                           T. Reddy, Ed.
                                                                  McAfee
                                                            M. Boucadair
                                                                  Orange
                                                       November 21, 2018

         Controlling Filtering Rules Using DOTS Signal Channel
            draft-nishizuka-dots-signal-control-filtering-00

Abstract

   This document specifies an extension to the DOTS signal channel to
   control the filtering rules during attack mitigation.

   This extension allows a DOTS client to activate or de-activate
   filtering rules during a DDoS attack.  The characterization of these
   filters is supposed to be conveyed by a DOTS client during peace time
   by means of DOTS data channel.

Editorial Note (To be removed by RFC Editor)

   Please update these statements within the document with the RFC
   number to be assigned to this document:

   o  "This version of this YANG module is part of RFC XXXX;"

   o  "RFC XXXX: Controlling Filtering Rules Using DOTS Signal Channel";

   o  reference: RFC XXXX

   o  [RFCXXXX]

   Please update these statements with the RFC number to be assigned to
   the following documents:

   o  "RFC SSSS: Distributed Denial-of-Service Open Threat Signaling
      (DOTS) Signal Channel Specification" (used to be
      [I-D.ietf-dots-signal-channel])

   o  "RFC DDDD: Distributed Denial-of-Service Open Threat Signaling
      (DOTS) Data Channel Specification" (used to be
      [I-D.ietf-dots-data-channel])

Nishizuka, et al.         Expires May 25, 2019                  [Page 1]
Internet-Draft        DOTS Signal Control Filtering        November 2018

   Please update the "revision" date of the YANG module.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on May 25, 2019.

Copyright Notice

   Copyright (c) 2018 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   3
     1.1.  The Problem . . . . . . . . . . . . . . . . . . . . . . .   3
     1.2.  The Solution  . . . . . . . . . . . . . . . . . . . . . .   4
   2.  Notational Conventions and Terminology  . . . . . . . . . . .   4
   3.  Controlling Filtering Rules . . . . . . . . . . . . . . . . .   4
     3.1.  Binding of the Data Channel and Signal Channel  . . . . .   4
     3.2.  DOTS Signal Channel Extension . . . . . . . . . . . . . .   5
       3.2.1.  Filtering Control . . . . . . . . . . . . . . . . . .   5
       3.2.2.  DOTS Signal Filtering Control Module  . . . . . . . .   6
         3.2.2.1.  Tree Structure  . . . . . . . . . . . . . . . . .   6
         3.2.2.2.  YANG Module . . . . . . . . . . . . . . . . . . .   6
   4.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   9

Nishizuka, et al.         Expires May 25, 2019                  [Page 2]
Internet-Draft        DOTS Signal Control Filtering        November 2018

     4.1.  DOTS Signal Channel CBOR Mappings Registry  . . . . . . .   9
     4.2.  DOTS Signal Control Filtering YANG Module . . . . . . . .   9
   5.  Security Considerations . . . . . . . . . . . . . . . . . . .  10
   6.  Acknowledgements  . . . . . . . . . . . . . . . . . . . . . .  10
   7.  References  . . . . . . . . . . . . . . . . . . . . . . . . .  10
     7.1.  Normative References  . . . . . . . . . . . . . . . . . .  10
Show full document text