MPLS LDP Query Message Description
draft-paraschiv-mpls-lsp-query-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Peter J. Ashwood-Smith , Antonela Paraschiv | ||
Last updated | 2000-07-19 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes the encoding and procedures for two new LDP messages, the Query Message and Query-Reply Message. An LER sends a Query message when it needs to find out information about an LSP. The Query message is sent for an established LSP. The Query message can be used for LDP LSPs as well as for CR-LSPs. The queried data is encoded into the Query-Reply message and partially into the Query Message.
Authors
Peter J. Ashwood-Smith
Antonela Paraschiv
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)