TDM Service Specification for Pseudo-Wire Emulation Edge to Edge (PWE3)
draft-pate-pwe3-sonet-vt-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Prayson Pate | ||
Last updated | 2002-06-25 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes the service-specific implementation and requirements for Pseudo-Wire Emulation Edge-to-Edge (PWE3) of TDM circuits using SONET/SDH payload formats. This draft extends SONET/SDH SPE emulation proposal [CEP-SPE], providing SONET VT1.5/2/3/6 and SDH VC-11/12/2 circuit emulation. This draft also provides bandwidth saving modes for SONET STS-1 and SDH VC-3/4 carrying tributaries or asynchronous T3/E3 signals. This proposal is optimized for VT level cross connect applications, for PDH to SONET/SDH emulation and for carrying PDH circuits across a PSN. The applicability statement for TDM circuit emulation (PDH and SONET/SDH) is described in [TDM-APP]. This draft discusses the emulation of these circuits over packet networks using IP or MPLS.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)