TDM Service Specification for Pseudo-Wire Emulation Edge-to-Edge (PWE3)
draft-pate-pwe3-tdm-03
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Prayson Pate , Ron Cohen , David Zelig | ||
| Last updated | 2002-01-22 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes the service-specific implementation and requirements for Pseudo-Wires Emulation Edge-to-Edge (PWE3) of TDM circuits. It discusses the emulation of circuits (such as T1, E1, T3 and E3) over packet networks using IP, L2TP or MPLS.
Authors
Prayson Pate
Ron Cohen
David Zelig
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)