Extensions to RSVP-TE for Point to Multipoint TE LSPs
draft-raggarwa-mpls-rsvp-te-p2mp-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Rahul Aggarwal | ||
| Last updated | 2004-10-28 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes extensions to Resource Reservation Protocol - Traffic Engineering (RSVP-TE) for the setup of point-to-multipoint (P2MP) Label Switched Paths (LSPs) in Multi-Protocol Label Switching (MPLS) and Generalized MPLS (GMPLS) networks. The solution relies on RSVP-TE without requiring a multicast routing protocol in the Service Provider core. Protocol elements and procedures for this solution are described. There can be various applications for P2MP TE LSPs such as IP multicast. Specification of how such applications will use a P2MP TE LSP is outside the scope of this document.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)