Skip to main content

Inter-Area P2MP Segmented LSPs
draft-raggarwa-mpls-seamless-mcast-03

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Yakov Rekhter , Rahul Aggarwal , Thomas Morin , Irene Grosclaude , Nicolai Leymann , Samir Saad
Last updated 2012-10-10 (Latest revision 2011-03-14)
Replaced by draft-ietf-mpls-seamless-mcast
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-mpls-seamless-mcast
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document describes procedures for building inter-area point-to- multipoint (P2MP) segmented service LSPs by partitioning such LSPs into intra-area segments and using BGP as the inter-area routing and label distribution protocol. Within each IGP area the intra-area segments are either carried over intra-area P2MP LSPs, using P2MP LSP hierarchy, or instantiated using ingress replication. The intra-area P2MP LSPs may be signaled using P2MP RSVP-TE or P2MP mLDP. If ingress replication is used in an IGP area then MP2P LDP LSPs or P2P RSVP-TE LSPs may be used in the IGP area. The applications/services that use such an inter-area service LSP may be BGP MVPN, VPLS multicast or Internet multicast over MPLS.

Authors

Yakov Rekhter
Rahul Aggarwal
Thomas Morin
Irene Grosclaude
Nicolai Leymann
Samir Saad

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)