Point-to-Multipoint Pseudo-Wire Encapsulation
draft-raggarwa-pwe3-p2mp-pw-encaps-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Rahul Aggarwal , Frederic JOUNAY | ||
| Last updated | 2010-03-08 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
A Point-to-Multipoint (P2MP) Pseudowire (PW) is a mechanism that emulates the essential attributes of a P2MP Telecommunications service such as P2MP ATM over a Packet Switched Network (PSN). This document describes the encapsulation and data plane procedures for a P2MP PW. These procedures are meant to be independent of the control plane used to signal a P2MP PW.
Authors
Rahul Aggarwal
Frederic JOUNAY
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)