MVPN: Customer IPv6 Using PIM Control Plane and S-PMSI Join Messages
draft-rosen-l3vpn-mvpn-spmsi-joins-01
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Yiqun Cai , Eric C. Rosen , IJsbrand Wijnands | ||
Last updated | 2010-09-14 (Latest revision 2010-05-21) | ||
Replaced by | draft-ietf-l3vpn-mvpn-spmsi-joins | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-l3vpn-mvpn-spmsi-joins | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The specification for Multicast Virtual Private Networks (MVPN) contains an option that allows the use of PIM as the control protocol between provider edge routers. It also contains an option that allows UDP-based "S-PMSI Join" messages to be used to bind particular customer multicast flows to particular tunnels through a service provider's network. This document extends the MVPN specification so that these options can be used when the customer multicast flows are IPv6 flows.
Authors
Yiqun Cai
Eric C. Rosen
IJsbrand Wijnands
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)