Skip to main content

Interoperability Test Profile
draft-rosen-megaco-test-profile-00

Document Type Expired Internet-Draft (individual)
Expired & archived
Author Brian Rosen
Last updated 2000-07-20
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document describes a profile for use in interoperability testing of the Megaco/H.248 protocol and a set of scenarios to try increasingly difficult mechanisms in the protocol. To support early phase testing, it is useful to define a simple, easy to implement set of characteristics that allow initial implementations to get very basic functions working. By implementing this profile, testing a variety of MGs against a variety of MGCs is possible. The test scenarios describe high-level behavior expected by the MGs and MGCs, but not explicit message sequences. Also included is a set of test messages that may be used to verify early stage MG/MGC functionality. They could be used to test parsers, and they can be used to assure that implementations have base functionality prior to testing with devices that may not produce the same messages.

Authors

Brian Rosen

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)