A+P for Dual-Stack Mobile IPv6
draft-sarikaya-aplusp-dsmip-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Behcet Sarikaya , Frank Xia , Mohamed Boucadair | ||
| Last updated | 2009-10-08 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This memo describes how to use IPv6 Port Range transition technique in mobile networks for Dual-Stack Mobile IPv6 (DSMIPv6). Using the client based DSMIPv6, a mobile node (MN) which is a dual-stack node can be assigned with a shared IPv4 Home Address (HA) together with a port range from the home agent. HA is co-located with Port Range Router (PRR). IPv4-in-IPv6 encapsulation is used to convey IPv4 traffic between the network and the mobile node (MN). HA, acting as PRR receives incoming IPv4 datagrams and determines the routing identifier (IPv6 address) to use to forward the traffic to the appropriate MN among those sharing the same IPv4 address. In the binding mode, HA finds the binding cache entry for this MN and then encapsulates the IPv4 datagram in an IPv6 one and forwards the encapsulated datagram to MN. The stateless mode is also described. Within this memo, Mobile network could be WiMAX network or 3GPP Long Term Evolution (LTE) network.
Authors
Behcet Sarikaya
Frank Xia
Mohamed Boucadair
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)