Multicast Support for Mapping of Address and Port Protocol and Light Weight 4over6
draft-sarikaya-softwire-map-multicast-04

Document Type Expired Internet-Draft (individual)
Last updated 2015-12-10 (latest revision 2015-06-08)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-sarikaya-softwire-map-multicast-04.txt

Abstract

This memo specifies multicast component for MAP and Light Weight 4over6 so that IPv4 hosts can receive multicast data from IPv4 servers over an IPv6 network. The solution developed is based on translation. In the Translation Multicast solution for MAP (MAP-E and MAP-T) and lw4o6, IGMP messages are translated into MLD messages and sent to the network in IPv6. MAP Border Relay/lwAFTR does the reverse translation and joins IPv4 multicast group for the hosts. Border Relay/lwAFTR as multicast router receives IPv4 multicast data and translates the packet into IPv6 multicast data and sends downstream on the multicast tree. Member CEs/lwB4s receive multicast data, translate it back to IPv4 and transmit to the hosts.

Authors

Behcet Sarikaya (sarikaya@ieee.org)
Hui Ji (jihui@chinatelecom.com.cn)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)