Multi-address Interface in the Socket API
draft-sarolahti-mptcp-af-multipath-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Pasi Sarolahti | ||
Last updated | 2010-03-04 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies a new address family to be used for sockets that are bound to more than one IP address, as motivated by the Multipath TCP work in the IETF. The goal is to use the same set of function calls as traditionally, but by new address family make it possible for them to express multiple addresses to connect or bind to. The document gives a high-level definition of the behavior of the traditional function calls, but a detailed specification of the API syntax is not in the scope of this document.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)