Reliable QUIC Stream Resets
draft-seemann-quic-reliable-stream-reset-02
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Marten Seemann | ||
| Last updated | 2023-03-25 | ||
| Replaced by | draft-ietf-quic-reliable-stream-reset | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-quic-reliable-stream-reset | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
QUIC ([RFC9000]) defines a RESET_STREAM frame to reset a stream. When a sender resets a stream, it stops retransmitting STREAM frames for this stream. On the receiver side, there is no guarantee that any of the data sent on that stream is delivered to the application. This document defines a new QUIC frame, the RELIABLE_RESET_STREAM frame, that resets a stream, while guaranteeing reliable delivery of stream data up to a certain byte offset.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)