Skip to main content

Multi-Site Solution for Ethernet VPN (EVPN) Overlay
draft-sharma-bess-multi-site-evpn-02

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Active".
Expired & archived
Authors Lukas Krattiger , Ayan Banerjee , Ali Sajassi , Rajesh Sharma , Raghava Sivaramu
Last updated 2022-11-13 (Latest revision 2022-05-12)
RFC stream (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document describes the procedures for interconnecting two or more Network Virtualization Overlays (NVOs) via NVO over IP-only network. The solution interconnects Ethernet VPN network by using NVO with Ethernet VPN (EVPN) to facilitate the interconnect in a scalable fashion. The motivation is to support extension of Layer-2 and Layer- 3, Unicast & Multicast, VPNs without having to rely on typical Data Center Interconnect (DCI) technologies like MPLS/VPLS. The requirements for the interconnect are similar to the ones specified in [RFC7209] "Requirements for Ethernet VPN (EVPN)". In particular, this document describes the difference of the Gateways (GWs) procedure and incremental functionality from [RFC9014] "Interconnect Solution for Ethernet VPN (EVPN) Overlay Networks", which this solution is interoperable to. This document updates and replaces all previous version of [SHARMA-MULTI-SITE].

Authors

Lukas Krattiger
Ayan Banerjee
Ali Sajassi
Rajesh Sharma
Raghava Sivaramu

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)