Labels for MPLS over LAN Media
draft-srinivasan-mpls-lans-label-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Hiroshi Esaki , Wayne Pace , Anoop Ghanwani , Shigeo Matsuzawa , Dick R. Bussiere | ||
| Last updated | 1997-09-09 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Multi Protocol Label Switching (MPLS) refers to a forwarding paradigm for routed networks which combines the speed and simplicity of link layer switching with the scalability and control of network layer forwarding. Routers which support MPLS are referred to as Label Switching Routers (LSRs). MPLS requires the distribution labels between peer LSRs based on routing and traffic information. These labels are then carried in packets and are used for making high speed forwarding decisions at the routers by eliminating the need for conventional network layer header processing. This note discusses the format and encapsulation of labels when using MPLS on LAN media.
Authors
Hiroshi Esaki
Wayne Pace
Anoop Ghanwani
Shigeo Matsuzawa
Dick R. Bussiere
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)