Skip to main content

DHCPv6 Bulk Leasequery

Document Type Replaced Internet-Draft (individual)
Expired & archived
Author Mark Stapp
Last updated 2008-10-27 (Latest revision 2007-10-15)
Replaced by draft-ietf-dhc-dhcpv6-bulk-leasequery
RFC stream (None)
Intended RFC status (None)
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-dhc-dhcpv6-bulk-leasequery
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:


The Dynamic Host Configuration Protocol for IPv6 (DHCPv6) has been extended with a Leasequery capability that allows a client to request information about DHCPv6 bindings. That mechanism is limited to queries for individual bindings. In some situations individual binding queries may not be efficient, or even possible. This document specifies extensions to the Leasequery protocol that add new query types and allow for bulk DHCPv6 binding data transfer.


Mark Stapp

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)