LSR Self-Test
draft-swallow-mpls-lsr-self-test-00
| Document | Type | Expired Internet-Draft (individual) | |
|---|---|---|---|
| Authors | George Swallow , Dan Tappan | ||
| Last updated | 2003-06-26 | ||
| Stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats |
Expired & archived
plain text
htmlized
pdfized
bibtex
|
||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
https://www.ietf.org/archive/id/draft-swallow-mpls-lsr-self-test-00.txt
Abstract
This document defines a means of self test for a Label-Switched Router (LSR) to verify that its dataplane is functioning for certain key Multi-Protocol Label Switching (MPLS) applications including unicast forwarding based on LDP [LDP] and traffic engineering tunnels based on [RSVP-TE]. A new Loopback FEC type is defined to allow an upstream neighbor to assist in the testing at very low cost. MPLS Echo Request and MPLS Echo Reply messages [LSP-Ping] messages are extended to do the actually probing.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)